The easy way to solve this is to remove the plug from the pads, then bridge a wire between the two wires.
Ja.On the dashboard check brake pad warning comes is there anyway to disable the sensor as i hav change pads?You'll find that theres brake dust/dirt on your sensors, give them a clean, this should solve the problem.
-x-On the dashboard check brake pad warning comes is there anyway to disable the sensor as i hav change pads?The caliper is earthing make sure the wear connection is not earthed.On the dashboard check brake pad warning comes is there anyway to disable the sensor as i hav change pads?pull the sensor pin out of the brakesOn the dashboard check brake pad warning comes is there anyway to disable the sensor as i hav change pads?go to autozone will remove it freeOn the dashboard check brake pad warning comes is there anyway to disable the sensor as i hav change pads?Strip back the wires on the con plug and join them together.On the dashboard check brake pad warning comes is there anyway to disable the sensor as i hav change pads?a number of different things, either clean wires, replace wires or take out dash board bulb.On the dashboard check brake pad warning comes is there anyway to disable the sensor as i hav change pads?depends on the make if bmw to far worn you will need to replace sensors mintex supply them for roughly 5 to 10 pounds.
vw some makes need to have a machine plugged in to reset them they are avaliable from draper or sealey but are costly 120 roughlyOn the dashboard check brake pad warning comes is there anyway to disable the sensor as i hav change pads?Your brake sensors need replaceing as said above. the pad has made contact with the metal indicator on the sensor itself and therefore cannot be used again. the warning on the dashboard will not go until you have installed a new set of warning sensors. i very much doubt your car will need reset!On the dashboard check brake pad warning comes is there anyway to disable the sensor as i hav change pads?The only way it can be done is to replace the sensors. the curcuit has been broken. The fault has been brought up on the dash. They are there to indicate your brakes are worn. Stop being a tight ****!On the dashboard check brake pad warning comes is there anyway to disable the sensor as i hav change pads?YEA THAT'S ITOn the dashboard check brake pad warning comes is there anyway to disable the sensor as i hav change pads?Get it fixed. It's a safety feature. BTW it's not a low brake fluid level is it?
